Activity

HDPE waterproofing membrane products execute a congrats of keeping your house dry and tidy, it’s one of several good solutions for leaking houses because it is affordable, it’s low maintenance, and very convenient.

Even tho it’s a leaking roof or a room leaking to a higher level of occupants, it may cause damage to property along with neighborhoods. This is a ubiquitous architectural phenomenon, plus construction, leaking water is the second biggest symptom in building quality. Now, a lot of people took measures, waterproof coatings, waterproof membranes, and other products.

What are HDPE damp membranes?

HDPE damp membranes are actually a self-adhesive waterproof material, which includes the characteristics of superior performance, warm resistance, and durability. Furthermore, the self-adhesive film features a polymer adhesive layer.

HDPE damp membranes are made from high-quality high-density polyethylene resin, at one time, ultraviolet absorbers, anti-aging agents, etc. can also be used.

Options that come with HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

An easy task to construct

Castable skeleton steel bar

It might form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Able to walk

As soon as the waterproof layer is fully gone, it is usually directly stuck just using the effect resistance of reinforced concrete without having a protective layer

Low requirements for your base layer, and can be constructed on uneven and wet base surfaces

Not suffering from objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Whether it’s the rooftop the main ramp, the waterproofing with the tunnel, and also the pool, it could be perfectly waterproofed. Simultaneously, HDPE damp membranes can be used high-requirement waterproof projects plus some gas leakage prevention.

Installation tips

Maintain your lower layer clean first. If your sharp area of the protrusion is located, it’s going to be processed to get flat. In case there are more water stains, maintain the lower layer moist.

Unroll the membrane. When laying the film around the base layer, you should take note of the particles in the film facing up, as well as the edges present in adjacent films have to be aligned to prevent overlapping.

The best way to determine the thickness in the film meets what’s needed?

This technique is quite brief, require a needle and randomly select 3 points per 100 square meters about the membrane for penetration experiments. Dimensional measurements were made for your thickness in the 3 needle punches respectively, and finally, the average value was taken for his or her heights. When the average thickness is greater than 1.5mm, it meets certain requirements.

More details about màng hdpe check out our new web portal: visit here