Activity

HDPE waterproofing membrane products do a congrats of keeping your house dry and tidy, it’s among the good solutions for leaking houses as it’s affordable, it’s low maintenance, and it’s very convenient.

It could be a leaking roof or even a room leaking to a higher level of occupants, you can get damage to property and also neighborhoods. It is a ubiquitous architectural phenomenon, along with construction, leaking water may be the second biggest problem in building quality. Now, many people have measures, waterproof coatings, waterproof membranes, along with other products.

What are HDPE damp membranes?

HDPE damp membranes have been a self-adhesive waterproof material, which includes you will of superior performance, hot temperature resistance, and durability. In addition, the self-adhesive film includes a polymer adhesive layer.

HDPE damp membranes are constructed with high-quality high-density polyethylene resin, and at once, ultraviolet absorbers, anti-aging agents, etc. are also used.

Top features of HDPE waterproof membrane

Durable

Long-lasting

Less maintenance

Supports construction on wet bases

Very easy to construct

Castable skeleton steel bar

It can form a super-strong bond with concrete, thus preventing the penetration of rain and moisture

Willing to walk

Following the waterproof layer is fully gone, it can be directly associated with the impact resistance of reinforced concrete with out a protective layer

Low requirements for the lower layer, and could be constructed on uneven and wet base surfaces

Not impacted by objective factors, thereby reducing construction costs

More flexible construction methods

Good waterproof performance

Widely application

Whether it is the cover section of the ramp, the waterproofing with the tunnel, and also the pool, it is usually perfectly waterproofed. Concurrently, HDPE damp membranes can be used high-requirement waterproof projects and a few gas leakage prevention.

Installation tips

Keep your lower layer clean first. When the sharp part of the protrusion is found, it’s going to be processed to get flat. In case there are more water stains, keep the lower layer moist.

Unroll the membrane. When laying the video around the first layer, you have to take note of the particles with the film facing up, as well as the edges of the adjacent films need to be aligned to stop overlapping.

How you can determine the thickness of the film meets certain requirements?

Using this method is very brief, please take a needle and randomly select 3 points per 100 square meters for the membrane for penetration experiments. Dimensional measurements were made for your thickness of the 3 needle punches respectively, and finally, the average value was taken for heights. If the average thickness is greater than 1.5mm, it meets the needs.

For more information about màng chống thấm hdpe view our new site